Evening,
Back at it today, hope you had a very nice Mother's Day. This picture was taken after replacing the weather seals around the door. Of interest again is the molded plastic water 'shield' that in this case has been damaged and the outer portion is broken off-that's why you can see the hole in the door. As a consequence the door card was/is warped and didn't fit well. At some point you might want to replace the door cards but that can be done some time in the future should you so desire. I was pleased that I was able to get the door to fit better, it was VERY close at the front top and the bottom was to far out but with a little adjustment of the hinge allowed me to get a much better fit IMHO.
 |
| Door installed with door card and trim, found and installed the lower trim piece that was in the boot. There is a bodge on the door that I had to do in this picture, see if you can find it. Answer tomorrow ;-) |
 |
| Nice fitting passenger door. |
 |
| Gear shift gator, it was split from age and use, took it apart, made a pattern and will sew a new one. That's all folks, Cheers, Lynn 5.5 hrs |
Ah, you taped up the cracks. Good idea.
ReplyDeleteGorilla tape, hope it holds. I'll probably use it to seal the transmission cover to the body if it sticks.
ReplyDeleteThanks for your interest Drew, always appreciate an audience!
Lynn